How to Set Up Tank Level Sensor

How to Set Up Tank Level Sensor

Veeder-Root, we will set this up and enable it as long as long as you're on our Business Plan. Here are the prerequisites:

TLS = Tank Level Sensor AKA ATG = Automatic Tank Gauge

There are two kinds of TLS integrations:

  • Direct - Our system communicates directly with the TLS/ATG.

  • Indirect/Proxied - Our system pulls the data indirectly through the POS system.

If the site had a non-Veeder-Root TLS/ATG, then you MUST do Indirect/Proxied. This is done by:

  • Adding a Serial Card to the TLS/ATG (may already be there)

  • Running a Serial cable over RJ45 to the POS system.

  • Configuring the POS system to pull from the TLS/ATG.

  • After the above,  let support know and we can tell our system to begin pulling the data from the POS.

If the site has a Veeder-Root TLS/ATG and wants direct:

  • Benefits of Direct:

  • More accurate data

  • Delivery tracking

  • Auto-alarm shutoff

  • Alarm/alert/warning recording

How:

  • Ensure the site had a Veeder-Root on a minimum of Software revision 15 or later (21 or later preferred) - if not you will need a Veeder-Root tech to come and upgrade the Veeder-Root software

  • Install a TCP/IP card on the Veeder-Root (we can come out and do this for the site or you can have a tech come out, we charge a flat fee of $500 for install & the card - if site is over 100 miles from Stuart, FL add cost of a plane ticket)

  • Contact our support and let us know the new IP address so we can begin pulling

    • Related Articles

    • Not Found SKUs Set Up

      First you will need to create a new department in the stores back office Label it as Not Found SKUs and under the "Is Not Found" Tab choose yes. Click Save Changes In your department list look for this newly created Department and find its Department ...

    • How to Set Up Check Cashing.

      In order to cash out a check, a new department needs to be created. Start by going to Store Management and then Department. FInd the + New Department Button on the top right. In the new menu that appears write the name as Check Cashing and then set ...

    • How set a Coupon Key on your SuperSonic POS.

      Go to Store Management and the select Departments. On the top right, select the + New Department Button. In the menu that appears, name the new Department Coupons and then set the correct flags. Negative set to Yes. and Not Inside Sales set to Yes. ...

    • How to Set Ad on Customer Side of SuperSonic POS

      Setting an ad will replace the Welcome to Store displayed on the white background on the customer's side of the SuperSonic POS. Go to Store Management and then select Registers. Here will be the list of registers under the store. On the right hand of ...

    • How to set up Remote Support Client.

      Begin by going to https://petrooutlet.com/ and scroll down to the bottom of the page. At the bottom of the page, on the right hand side there will be a Resources section. Select Remote Support. One the new page, the Welcome to the Petro Outlet Remote ...